86-15915757872
86-13602308576
86-15915757872

How much do you know about the accident handling tips of automatic labeling machine?

Release date:2024.12.19

Especially in the use of mechanical equipment, grasp some common sense, for us, it is very useful, can help quickly solve the problem, our automatic labeling machine is the same, then automatic labeling machine accident handling little common sense you know how much?

1. Adjustment of label box:

Adjustment of the position of the hook of the box: the hook of the upper and lower, left and right are on the same vertical plane and are evenly labored on the marking paper, so that the mark can be grasped smoothly. The gap between the label paper and the bar on both sides should be between 0.8mm and 1mm, the gap is too large to cause the label paper to shift in the label box, and the skew mark appears, and the gap is too small to cause the push mark. The center line of the label box, the center axis of the label station and the label paper are tangent, the center axis of the label board is in a line at three points, adjust the tangent of the label board and the label paper (0 distance), and then move the label box closer to 1mm ~ 2mm. The label provides roller adjustment: When there is no label, the label pressure plate can be pressed to the most front of the label box and the label near the hook finger cannot be crushed.

2. Adjustment of the standard station:

Adjustment of the roller and the plate: the plate and the roller only contact each other without any pressure. The gap is too large, too much glue on the plate, resulting in glue. If the gap is too small and the contact is too tight, the glue will be squeezed away, and there is no glue on one side of the label board. Adjustment of scraping plate and roller: there can be no gap between the scraping plate and the roller in the entire length. If there is a gap, the scraping plate can be adjusted by adjusting the eccentric bolt. Practice has proved that the gap between the label plate and the roller is between 0.1mm and 0.2mm. This can be achieved by adjusting the bearing seat on the lower part of the roller, and adjusting the bearing on the upper part of the roller if necessary.

3. Adjustment of brush press device:

Pressure head adjustment; The pressing head should be 20mm lower without the bottle than with the bottle. The overlap gap between the brush and the container is 10mm to 15mm for a single brush and 5mm to 10mm for a combined brush. The distance between the cleaning brush and the sponge should be 1mm to 2mm. The center of the brush is aligned with the label and symmetrical on both sides. The marker brush is perpendicular to the surface of the container.

4, into the bottle star wheel, out of the bottle star wheel, into the bottle screw adjustment:

Exit star wheel adjustment: When the press head is just raised, adjust the star wheel so that the bottle is in the middle of the groove of the star wheel. Adjustment of the screw into the bottle: when the bottle is in the middle of the groove of the star wheel into the bottle, adjust the screw so that the screw into the bottle side is tight to the bottle but does not displace. When adjusting the star wheel and screw rod in and out of the bottle, the bottle pressing head of the marking machine shall prevail. First adjust the inlet star wheel, when the bottle press head is just over the bottle, adjust the inlet star wheel so that the bottle is in the middle of the star wheel groove.